Design and Characterisation of Screen-Printed Piezoresistive Cantilever for Strain Sensor Application

Authors

  • Naouras Saleh Department of Electrical Engineering Technology, Faculty of Electrical Engineering & Technology, Universiti Malaysia Perlis, 02600 Arau, Perlis, Malaysia
  • Nursabirah Jamel Department of Electrical Engineering Technology, Faculty of Electrical Engineering & Technology, Universiti Malaysia Perlis, 02600 Arau, Perlis, Malaysia
  • Omar Al-Khadher Department of Electrical Engineering Technology, Faculty of Electrical Engineering & Technology, Universiti Malaysia Perlis, 02600 Arau, Perlis, Malaysia
  • Illani Mohd Nawi Department of Electrical Engineering, Faculty of Engineering, Petronas University of Science and Technology, Perak, Malaysia

Keywords:

Screen-printed technologystrain sensorflexible sensorpiezoresistive sensor

Abstract

This work addresses the increasing demand for reliable, sustainable and sensitive sensor devices in the sensing field. Conventional methods usually use silicon as substrates and present challenges such as inflexibility and limitations of the substrate that can be used. To overcome this, in this work, a sensitive substrate such as Bristol paper based on screen printed piezoresistive for strain sensor has been designed, fabricated, and tested. A 350 gsm Bristol paper was used as the substrate material, and graphite and silver ink were used as piezoresistive and electrode pad, respectively. The screen-printing method was used to fabricate the strain sensor. The proposed sensor can measure a strain range from 5 mN to 19.6 mN with a force resolution of 196 uN. The implemented sensor has a sensitivity of 0.38 N −1

Downloads

Published

2025-06-30

Issue

Section

Articles